[osflash] Using components in FAME development

[Justin Clarke]

Hi there,
 I've got a problem that's surely been answered, but after searcing high 
and low I can't find the answer. I've been doing Flash dev using Eclipse 
etc and loving it, but now I've got to the stage in a project where I 
need a button component. I've added that to the library from within MM's 
IDE, and when I compile the first time in Eclipse it's fine - I use the 
-mx switch to avoid errors and everythings a-ok. But every compile after 
that the swf causes the "A script is running slowly..." message, and 
debug statements get outputted multiple times, as if there are multiple 
versions running at the same time within the swf. I actually have to go 
back into the MM IDE, recompile the original swf, and then I'm able to 
compile again in Eclipse (once, of course, before it starts tanking again).

After reading up on this I thought the answer was to keep the source swf 
generated by MM IDE untouched, and use the -out option in MTASC to 
generate a new file. This works fine, except that within Eclipse the 
Flashout displays the source swf, not the -out putted  swf. If anyone 
can point out the correct way to add components I would be very 
grateful, because I clearly haven't found the solution!

cheers,
justin.