[Papervision3D] Removing the top and bottom of a cylinder (tube)

[Dustin Sparks]

I read about someone else on the list who also tried to do this, but I can't
seem to figure it out.

I need to remove the top and bottom from the cylinder. Someone mentioned
extending the cylinder class and overwriting the method that draws the top,
however the cylinder class is a bit much for me since there are no comments
and the variables are confusing to me.

It's not a huge problem since i plan on constraining the camera to only show
the inside of the cylinder, but it would be nice to have it figured out.

-- 
[ Dustin J Sparks ]
Interactive Developer / Creative Technologist
p. (765) 273-4793
http://djsparks.iweb.bsu.edu/portfolio/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://osflash.org/pipermail/papervision3d_osflash.org/attachments/20080220/143bf6c5/attachment.html